TestStand and LabVIEW program

€8-30 EUR

Anuluar

Postuar

almost 4 years ago

€8-30 EUR

Paguhet në dorëzim

Need and expert TestStand environment with LabVIEW to do a sequential test for a small Pump with heater.. The Software for the sequence is already done in Labview and we need to do the same test With TestStand using the PC example in TestStand tools as a template with Images and animation... We need also to simulate the Pump externally to test our sequence without the phisical module... This is a micro project and for an expert it would take a few hours since the LabVIEW part is already done...

LabVIEW

Arduino

Software Architecture

Electronics

Assembly

ID e Projektit: 26243177

Rreth projektit

4 propozime

Projekt në distancë

Aktive 4 yrs ago

Po kërkoni të fitoni para?

Adresa e email-it

Përfitimet e ofertës për Freelancer

Vendosni buxhetin dhe afatin tuaj

Paguhuni për punën tuaj

Përshkruani propozimin tuaj

Është falas të regjistrohesh dhe të bësh oferta për punë

I dhënë për:

@hggujarati7

A Certified LabVIEW Developer with 3.5+ years of experience in design and development of Automated Test Equipment (ATE) systems using National Instruments (NI) Hardware & Software.

€111 EUR në 3 ditë

0,0

(0 përshtypje)

0,0

4 freelancers are bidding on average €48 EUR for this job

@PKonstiantyn

Hello, I am an Electrical and Electronics Engineer and I completed my master's degree. I have developed in TestStand environment with LabVIEW to do a sequential test for a small Pump with heater. I can simulate the Pump externally to test our sequence without the phisical module with labview. Thanks to the electronic circuit design programs I can use, I can design and test the circuit. I guarantee free support at all times if there is any problem when the project is over. Best regards! Konstiantyn.

€50 EUR në 2 ditë