Connecting sensor with lattice FPGA

HELLO I AM FPGA EXPERT I KNOW FPGA,ASIC,VHDL PROGRAMMING VERY WELL I HAVE DONE MANY PROJECTS BEFORE SO I CAN DO YOUR PROJECT TOO

Dear Client, I have read your project description carefully. I would like to have a specific discussion with you about the details of the project. Please leave a message on my chat so we can discuss the budget and deadline of the project. I have 6 years of experience in hardware design engineer design. I'm familiar with VHDL, verilog, SystemVerilog,spi,uart,usb,microblaza, testbench,AXI IP,FPGA,ASIC,SOC, schematic,pcb etc. If you agree that my experience and qualifications are a close fit for your needs, I would be delighted to get a reply from you. Regards, Athul. B

Hello, To interface a lattice FPGA with an ultrasonic sensor and lidar sensor for connecting an MIPI-based camera module, you can use the following steps: Connect the ultrasonic sensor and lidar sensor to the FPGA Configure the FPGA to read data from the sensors and store it in memory Connect the FPGA to the microcontroller using the SPI interface Write software to communicate with the FPGA over the SPI interface and read the sensor data Use the sensor data in your application as needed. It is important to note that the sensor types will affect the specific steps and configuration required to interface them with the FPGA. It is good to provide the sensor's datasheet and application notes to get more information on how to interface them with the FPGA. Thanks,

Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more than 9 years of experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded systems, microcontrollers, Proteus, Arduino, ESP32, Raspberry pi, NB-IoT, MATLAB, PLC Design, Algorithm, and Product design. I can assure satisfactory work. I'll be glad to work with you. Thanks