Simple Android Project switch and buzzer must be completed and submitted in tinkercad.com

$10-30 USD

I përfunduar

Postuar

almost 3 years ago

$10-30 USD

Paguhet në dorëzim

Build it in [login to view URL] to test and submit. See attached document with nice table showing all conditions. But I will try to write it out for you here: - 12 volt power supply must be used to power Arduino. (Make it simple and efficient for power) - There is momentary switch (normally open), On/Off switch, Buzzer and 2 LEDs. - Depending on the condition of the switches the buzzer and LED will sound and flash. For details about the timing and conditions see the attached document. I will email you a shared link where you can build it and test in my tinkercad. Check out [login to view URL] and setup you own account so I can share a link if this project is awarded to you. Thank You! Jim

ID e Projektit: 30568878

Rreth projektit

4 propozime

Projekt në distancë

Aktive 3 yrs ago

Po kërkoni të fitoni para?

Adresa e email-it

Përfitimet e ofertës për Freelancer

Vendosni buxhetin dhe afatin tuaj

Paguhuni për punën tuaj

Përshkruani propozimin tuaj

Është falas të regjistrohesh dhe të bësh oferta për punë

I dhënë për:

@soltracker

Its me Imad, The number of simulations done myself in tinkercad and proteus are around 500. Thanx for posting the job.......................

$30 USD në 2 ditë

4,8

(59 përshtypje)

4,7

4 profesionistët e pavarur ofrojnë mesatarisht $34 USD oferta për këtë punë

@Gerrard97

Hello, thank you for your job posting. I read your description about your project I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can write the firmware based on Arduino, Raspberry Pi, Pic, Atmega, FPGA, ARM, DSP, PLC and so on. And I can design the circuit by the Altium, Eagle, KiCAD, Allegro & OrCAD, PADs. I provide the services - Gerber files, Netlist generation, BOM generation and 3D Models of PCAD and ECAD. I am also good at AutoCAD, Solidworks. And I can simulate all circuits with Proteus, LT-spice, Matlab, Simulink, Multisim, and Labview as well. Due to my experience in firmware development, I will bring you the perfect result in time with high quality. I will also give you a detailed explanation of the process. Looking forward to hearing from you soon Thanks

$20 USD në 7 ditë