To design Model Predictive Control on Shell Control Problem: Report
$30-250 USD
Mbyllur
Postuar almost 10 years ago
$30-250 USD
Paguhet në dorëzim
My topic is to design Model Predictive Control on Shell Control Problem There are so many researches about Shell Control Problem. This said, the process is strongly interactive and there are a great number of input as well as outputs. PID controller could do the good job for controlling the process but Model Predictive Controller could definitely do better. My requirement is full dissertation NOT INCLUDING LITERATURE REVIEW. Word count 5000 words NOT INCLUDING DESIGN/SIMULATION WORK - First, My aim is to use a process model which is available as the paper has attached to design PID controller including the process model in Simulink (Matlab). It seems the paper has done, just transfer to Simulink - Take step changes in setpoint to witness the effectiveness as the paper has shown - The next step is to replace PID control with Model Predictive Control using Model Predictive Control toolbox in Matlab - Change settings such as Predictive Horizon, Control Horizon, weight in process input, etc., to demonstrate the effectiveness of the controller - Finally, compare PID controller and Model Predictive Controller on that process. Requirement: - Images, graphs, results should be stated clear. The most important things is graphs about results on simulink, graph about design in simulink
HI ,
I am chemical engineer
very good at process design ,PID control ,
ill write good report for you
please award the project .
thanks
regards
DATTATRAY
Dear Sir,
I have experience in Matlab Simulink. I have done control loop performance assessment and optimization using matlab simulink in my undergrad thesis under supervision of a prominent Process Control Researcher.
I am sure that i will be able to do your job perfectly.
Best Regards
Cbasak
Your objective is very common in Process Control Application. I am a chemical engineer and very good in process control. What I have, a very particular skill to apply Matlab script and Simulink in process control application.
If I get this project I will ask you some question and then I hope I would be able to help you as best as I can. Thank you.